Coating selection
Define functional requirements and compare coating systems based on release performance, adhesion, temperature, chemical compatibility and maintenance.
Collaboration in diagnosing and experimentally investigating industrial challenges related to functional surfaces, materials and manufacturing processes. The scope of each activity is agreed according to the problem, objectives and available resources.
Define functional requirements and compare coating systems based on release performance, adhesion, temperature, chemical compatibility and maintenance.
Investigate contact materials, mold surfaces, roughness, wettability and process conditions relevant to separation.
Compare removal strategies and evaluate their impact on the underlying substrate.
Plan and interpret experiments addressing surface properties, wear, erosion and functional stability.
Metrology, machining, additive manufacturing and design of experiments for manufacturing challenges.
Research questions, experimental protocols, objective evaluation and transfer of validated results.
Examples of published research that addresses practical engineering problems. Results refer to the specific experimental or modelling conditions in each publication, not commercial performance guarantees.
Coatings · 2018
Challenge: Reduce dependence on liquid release agents while maintaining release performance.
Approach: Experimental coating comparison and monitoring of production cycles.
Result: The selected PFA coating enabled approximately 1,500 cycles without release agent, with few incidents under the study conditions.
Read the studyPolymers · 2025
Challenge: Improve adhesion between extrusion-printed polymers and a metal substrate.
Approach: Surface treatments, primer application, and tensile and shear testing.
Result: PETG showed higher bond strength than PLA under the tested conditions.
Read the studyJournal of Materials Research and Technology · 2024
Challenge: Evaluate the feasibility of producing customized metallic inserts by material extrusion.
Approach: Manufacture of Cr–Mo steel inserts and turning tests under different cutting conditions.
Result: Feed and depth of cut influenced wear more than cutting speed; the inserts operated within a process range comparable to commercial tools.
Read the studyMaterials · 2024
Challenge: Improve industrial drawing sequences for ZnAl15% wire used in spray metallization.
Approach: Analytical modeling and numerical simulation supported by experimental validation.
Result: The models provide a basis for assessing process limits and comparing redesign and optimization strategies.
Read the studyI collaborate and provide scientific and technical advice to Tecnimacor, a Spanish company specializing in the industrial application of technical and non-stick coatings. Our collaboration concerns functional surfaces, release performance and the evaluation of coating solutions.
As a member of the Manufacturing Engineering area in the Department of Mechanics at the University of Córdoba, I participate in scientific research projects, material and process characterization and knowledge transfer, subject to applicable university procedures.
Industrial collaboration and university research are distinct activities. The references above do not imply that Tecnimacor and UCO jointly provide all the services described.
Please describe the component or process, the issue observed, operating conditions, the materials involved and any tests already performed. An initial inquiry can help define the scope of an experimental study or joint research project.
Do not include confidential information in the initial message. Activities involving institutional resources or commitments are managed through the corresponding university procedures.